KISS ESC 2-5S 24A Race Edition-32bit brushless motor

Include: 1x KISS ESC 24A

Altri dettagli

KISS-ESC24
Nuovo prodotto

25,90 €iva inclusa.

Questo prodotto non è più disponibile

 
Altre informazioni

KISS ESC 24A RE FW 1.08

In the sense  of our KISS ESC line this ESC offer a great compability to a wide range of motors, the work of years went in to making the best possible here.
The fast 32it Arm Cortex CPU does a very good job and runs the ESC very effective, of course reaction times are top notch.
The 24 RE is layed out as a beefy ESC which  withstand quite some abuse due to FPV races, several mechanisms doing its best to protect your valuable equipment, the rating of 24A wont need direct cooling, mounting them partially covered is ok.

No need to worry with different firmwares, simply solder and fly (some solder skills are the only needed skills).
First ESC with with oneshot42 support (dont worry, Oneshot125 and  normal PWM are auto detected too).
Beside this, this is the first ESC who offer a easy to use telemetry function over the regular servo connector which you can use in combination with our KISS-FC, no external heavy parts needed anymore to have infos like voltage, ampere and even your RPM on your OSD (MinimOSD supported) or on your receiver LCD screen (Frsky-Taranis, f.e.).

optional Kiss carrier for the 24A RE

Of course these ESC can be used like any regular ESC, you just need to solder wires to them.

Scope of supply:
1x KISS ESC 24A RE assembled board


Particularities:

32-bit ARM Cortex MCU @ 48Mhz

- Telemetry capability (current, voltage and speed / RPM will be covered by the ESC itself and to compatible devices such as our KISS FC forwarded)
- overcurrent protection (measures the current and limited active at 30A)
- fast reacting overtemperature protection (reducing the gas when exceeding 120 ° C)
- Advanced Auto Timing (3.25 to 30 ° are at each engine step readjusted)
- For Race Multicopter Developed (24A continuous without direct cooling *)
- High max. Speed ??(450.000ERpm, 64.000Rpm at a 14POL Motor)
- small dimensions (19 x 27 mm)
- fine speed control (about 950 steps)
- no external ElKo (electrolytic capacitor) necessary **
- fast reacting gas changes
- linear throttle response
- Active freewheeling enabled (little diode losses resulting in higher efficiency)
- regenerative braking, thereby rapid throttle response at Decelerate (the ESC uses active freewheeling and regenerative braking, 2 independent features which relates to each other in different working states)
- Fast switching FET by the use of gate drivers
- minimal dead times by an adaptive dead time
- 2-5S LiPo capable **
- Oneshot42, Oneshot125 and normal (25 - 500Hz) PWM is detected automatically.


Made in Europe

This Device is ESD sensitive, take precautions in any way, this is no "your coffee is hot warning", its physics we can't avoid, the smaller electronic becomes, the more ESD sensitive it is.

Read the Wiki section for Electrostatic Discharge before soldering.

Write a review

KISS ESC 2-5S 24A Race Edition-32bit brushless motor

Include: 1x KISS ESC 24A

Write a review


Fai la tua domanda


questions Andrea on 15/10/2017
Domanda: Questi esc Kiss con che firmware vengono inviati?
Risposta: Hanno sempre l'ultima versione disponibile (al momento è la 1.08)
questions riccardo on 18/10/2016
Domanda: Salve, con esc kiss 24A race edition si potrebbero usare motori che assorbono fino a 30A di assorbimento massimo visto che nella descrizione degli esc è scritto che sopportano fino 30A? Non si corre il rischio di bruciarli se non ho capito male. Grazie
Risposta: Si, si possono usare in quanto presumo che anche i motori assorbano 30A solo nel picco e non 30A continuo, quindi anche gli ESC supportano 30A nel picco e non continuo.

Domanda sul prodotto

* Campi richiesti
Inviare

La domanda è stata inviata correttamente

30 altri prodotti della stessa categoria:

I clienti che hanno acquistato questo prodotto hanno comprato anche:

No products

To be determined Shipping
0,00 € Totale

Procedi con l'ordine